During the operation and use of the Horizontal forging machine, the staff must carefully do the following:

Do it seriously at work:
1. Stick to the job position, operate the equipment carefully, and do not do anything unrelated to the work. The manufacturer of the horizontal forging machine tells you to stop the machine and turn off the electricity and gas (steam) sources when you leave the equipment for some reason.
2. Use the equipment according to the technical specifications stipulated in the manual, and do not use the equipment beyond the specifications and overload.
3. Pay close attention to the lubrication of each part of the equipment, and refuel during the shift according to the lubrication instruction chart to ensure that all parts of the equipment are well lubricated.
4. Pay close attention to the working conditions of various parts of the equipment. If there are abnormal sounds, vibrations, temperature rises, peculiar smells, smoke, uncoordinated movements, failures, etc., you should stop the machine immediately for inspection, and continue to work after troubleshooting.
5. When adjusting the speed, changing molds, tools or wiping, and overhauling the equipment, it is necessary to stop the machine in advance and turn off the electricity and gas (steam) sources.
6. The manufacturer of the horizontal forging machine tells you that you should not disassemble the safety protection device and open the door cover of the distribution box (box), oil pool (box) and gearbox without authorization during work.
7. The horizontal forging machine manufacturer tells you that the equipment must be stopped immediately in case of an accident, protect the site, and report to the relevant departments for analysis and processing.
Do it carefully after work:
1. All operating devices, sliders, hammers, tool rests, etc. should be placed in non-working positions according to the instructions; turn off electricity and gas (steam) sources.
2.Horizontal forging machine manufacturers tell you to organize tools, parts and workplaces.
3. Clean the material head, material edge, oxide skin, sundries, etc. on the work site and equipment; wipe clean all parts of the equipment, and oil each sliding surface for protection.
4. Fill in the shift record.
The above are the problems that need to be paid attention to in the operation and use of the Horizontal forging machine, I hope it will be helpful to you.